China Wholesale Gps L1 L2 Antenna Factories – P/N:FAGPS.01,GPS Built In Antenna, GPS patch antenna 2-20cm cable length IPEX – Fullantenna

Model: FAGPS.01

（i） Dielectric Antenna
Center Frequency 1575.42MHz±3 MHz
V.S.W.R 1.5:1
Band Width ±5 MHz
Impedance 50 ohm
Peak Gain ＞3dBic Based on 7×7cm ground plane
Gain Coverage ＞-4dBic at –90°＜0＜+90°(over 75% Volume)
Polarization RHCP
（ii） LNA/Filter
LNA Gain(Without cable) 28dB
Noise Figure 1.5dB
Filter Out Band Attenuation (f0=1575.42 MHZ)
7dB Ｍin f0+/-20MHZ ;
20dB Ｍin f0+/-50MHZ;
30dB Ｍin f0+/-100MHZ
V.S.W.R ＜2.0
DC Voltage 2.7V/ 3.3V/3.0V/3-5V
DC Current 6mA Max
（iii）Mechanical
Weight ＜60gram
Size 22×22X7.7mm
Cable RG174 8cm
Connector without
（iv）Environmental
Working Temp -40℃~+85℃
Storage Temp. -45℃~+100℃
Vibration Sine sweep 1g(0-p)10~50~10Hz each axis

This is a small-size positioning and navigation module.
It can provide real-time location information, and support a variety of satellite navigation systems, including 32 tracking channels. Besides, the module can receive GNSS signal from 6 satellite navigation systems simultaneously, which include China BDS (Beidou navigation satellite system), the American GPS, the Russian GLONASS, European GALILEO, Japan QZSS and SBAS satellite augmentation system (WAAS, EGNOS, GAGAN MSAS), and realize the joint positioning, navigation and timing.
In serial output mode, the module is compatible with various mainboards equipped with serial output: Arduino, Raspberry Pi, STM32 and so on. The positioning accuracy error is measured at about 3m, basically the same as smartphones. The module’s power consumption is as low as 0.1W, and it can work continuously for a long time with a small power supply.
Built-in Active Antenna with great connectivity.
High-gain antenna for GPS.
This antenna is great for tracking navigation.
High quality cable, Super durability and pressure resistant.
Easy to install.